DKK 0,00
(fragt pris: 0,00)
Lightwin 3m LC - ST, 3 m, OM3, LC, ST
Varenr.: [10204672] | Producent: Lightwin | Model-nr.: LDP-50 LC-ST 3.0 OM3 | EAN: 9120042363411
Fjernlager (14-21 hverdage)
Varen er på fjernlager, leveringstiden er 14-21 hverdage. Mere info
Leveringsmuligheder - Klik på en mulighed for at vælge
Instabox - Pakkeboks
39,00
GLS - Pakkeshop
39,00
DAO - Hjemmelevering om natten og i de tidlige morgentimer
Perfekt til arbejdsdage - Levering inden kl. 06:00 - Klar når du vågner
45,00
GLS - Levering til hoveddøren
59,00
Afhentning i vores Pick-up point i Ringsted
19,00
Vis alle leveringsmuligheder (5)
DKK
314,00
ex. moms 251,20
Total inkl. fragt
353,00
Tilføj til liste
Funktionen kræver at man er logget ind. Opret en bruger og brug vores smarte liste system til at holde styr på fremtidige indkøb, faste indkøb eller ønskelister.
Send på mail
The diameter of a fi bre including coating is exactly 125µm. The ferrule in in the connector has a bore for this diameter. During the manufacturing process, the fi ber is pushed into this little bore, is glued and polished. The bigger the bore, the less central the fi ber can be put. In our assemblies we exclusively use ferrules with a bore of max. 125,5µm, meaning our fi bre has a room of only 0,5µm.
The ferrules are carefully selected, since only very few meet these requirements. The ferrules with greater tolerances are obviously easier to produce in large quantities and correspondingly also cheaper, however, you have to accept the drawback in quality due to the bigger bores.
Such standard ferrules generally offered on the market have tolerances of 128,5µm +/- 1µm. A simple calculation demonstrates the obvious disadvantage the impact may be in practice: Singlemode has a core diameter of 9µm. By using a ferrule with 128,5µm, you can face a core shift of 7µm if both fi bres are turning in the opposite direction when putting it in the ferrule. Our ferrules minimize this problem at its best possible extent.
Our singlemode ferrules have a bore with a diameter of 125,5µm for multimode the standard singlemode ferrules with 126,5µm is used, as for the 50µm multimode the tolerances may be a bit bigger.
The ferrules are carefully selected, since only very few meet these requirements. The ferrules with greater tolerances are obviously easier to produce in large quantities and correspondingly also cheaper, however, you have to accept the drawback in quality due to the bigger bores.
Such standard ferrules generally offered on the market have tolerances of 128,5µm +/- 1µm. A simple calculation demonstrates the obvious disadvantage the impact may be in practice: Singlemode has a core diameter of 9µm. By using a ferrule with 128,5µm, you can face a core shift of 7µm if both fi bres are turning in the opposite direction when putting it in the ferrule. Our ferrules minimize this problem at its best possible extent.
Our singlemode ferrules have a bore with a diameter of 125,5µm for multimode the standard singlemode ferrules with 126,5µm is used, as for the 50µm multimode the tolerances may be a bit bigger.